NEWS CENTER
Full Automatic Unmanned Packaging Line
Carton sealing machine troubleshooting
Time：
2023-04-03 18:00
Source：
1. sealing machine clip nail action is too slow or clip nail stroke is not enough: the bolt is loose, the front buckle or plate machine inner piece wear. At this time, you can tighten the bolt and pay attention to the correct position of the front buckle shaft. Can also replace the front buckle or plate machine inner piece, after completing the above action, test its function, if the stroke is too short then fine-tune the front buckle shaft upwards, if the action is slow then fine-tune the front buckle shaft downwards;
2. Air leakage at the piston rod: the ring at the bottom of the main body is damaged. The ring should be replaced at this point.
3. Air leakage at the exhaust port: damage to the switch valve ring or switch seat ring or damage to the piston ring. Replace the ring.
4. Air leak at the trigger: Damaged switching valve ring or switching seat ring. Replace the ring.
5. Loose drive ring cannot be positioned: plastic strip and drive spring are not flexible. Remove the plate machine combination and reassemble the spring tip or replace the plastic strip and transmission spring
News
2025-06-19
Customer Service Hotline
Email:lynnluo@dtralipackage.com
Website: www.dtralipackage.com
Tel: +86 757 23339689
Whatsapp: +86 13516641971
Guangdong DTRALIPACK Intelligent Packaging Equipment Co., LTD.
Powered by www.300.cn SEO
